Been in a fender bender?

Replace your 2010 Subaru WRX Front Bumper Brackets with these Reverse Engineered 3D printed front bumper support brackets. Designed to replace the original plastic mounts, these brackets ensure a snug fit between the bumper and headlight/guard, restoring alignment and stability.

✅ Perfect fit for 2010 Subaru WRX (may also fit 2008–2010 WRX/Impreza models – confirm before ordering)

✅ Strong, durable ASA

✅ Precision CAD modeled from OEM bracket for factory-like fit

✅ Easy installation – direct replacement, no modifications required unless sides are not symmetrical due to impact.

Print Recommendations (for makers):

Material: ABS or ASA recommended for durability (We use ASA)

Infill: 20%+

Wall Loops: 3-4

Supports: Yes (Tree Auto) 30deg Threshold

Layer Height: 0.2mm

Orientation: See third screenshot - The orientation of these are incredibly important as the stress points (where the screws go) need to be parallel to the bed for maximum strength

** NOTE: If you are replacing them due to a crash, understand that if the quarter panel is bent, you will need to adjust them accordingly - for example, one job we had one side fit perfectly and needed to adjust the otherside by 1mm - if theres no damage to the quarter then they will fit fine as they are symmetrical.

Making adjustments if needed - Sketch a box at the desired width at the place shown in the 3rd screenshot, extrude cut and the align the faces (see last photo).