An ADD-ON to the 3 CFS or 2 CFS stand

https://www.crealitycloud.com/model-detail/3cfs-stand-sliding-rails-non-overturning

https://www.crealitycloud.com/model-detail/2-cfs-stand-sliding-rails-non-overturning

by d_v_ermakov ( https://www.crealitycloud.com/user-profile/2015296294/models )

This print adds a top shelf to the 3 CFS or 2 CFS stand. Allows you to use the top tier for placing things than a CFS unit. In my scenario, I have (2) CFS and a SpacePi.

The shelf has the foot insert spacing for a CFS in case you eventually have one to place there. The shelf has a small rim to prevent things from rolling off and the back of the rim is notched to provide space for the PFTE tube or easy disconnect should a CFS be placed on this level.

I have provided 2 implementations. Firstly as a two part, left and right, to be able to print flat on the bed of a K2 Plus, or upright on a K2 or K2 Pro. The second is all one piece. It would need to be printed upright on a K2. I have not printed this large and thin of an item on my K2 Plus, so please use at your own risk of fear it would fall over.

I printed mine with PETG-CF as I had it available. If you are going to put a SpacePi on the shelf, the low heat from the exhaust will soften PLA over time and warp/sag the shelf. This is from experience on my prior, different, CFS rack.

You will need (8) M4-8mm screws and (8) M4 t-nut for V2020 to mount on the 3 CFS shelf.

3 CFS Stand ADD-ON - Top Shelf

0.2mm layer, 2 walls, 15% infill