Best material:

PLA+ recommended for clean surface definition and structural rigidity.

Matte PLA enhances the sculptural depth of the flowing strands.

Resin optional for smaller wearable versions requiring smoother curvature transitions.

Layer height:

FDM (Creality K1C): 0.12 mm for balanced detail and smooth organic flow

0.08 mm for premium surface refinement

Resin: 0.03–0.05 mm for ultra-smooth finish

Supports:

Yes, recommended.

The upper crossing strands create overhangs exceeding 45°.

Use tree supports, touching build plate only, low density (10–12%).

Carefully position to avoid marking visible outer curves.

Infill:

100% for wearable durability

20–30% gyroid for decorative scaling

Walls:

4 perimeters minimum to strengthen strand intersections and maintain rigidity.

Orientation:

Tilt 30° backward to reduce support contact on the most visible front-facing strands.

Avoid fully vertical orientation to prevent internal bridging stress.

Scale Suggestions:

18–22 mm inner diameter → wearable artistic ring

55–75 mm → modern decorative sculpture

110 mm → abstract display piece

AeroWeave Contour Band – Noah0x03