Description

4/24/25 updated

New file for Fluted Base & Top with more capacity and prints better when using layered Print.

Printed with Standard Generic White / Black - PLA 0r PETG

I needed a Dispenser for some DIY Ant Bait that I made up, and this is what I came up with.

It is an easy print @.24 that took about 55Vminutes on my Kobra 3 Combo in two colors.

Works very well and is pet safe.

Recipe below was updated to use more Borax, which killed the ants & colony in 3 Days.

Just add a little of the DIY Bait ( Recipe Below) and Your Ants will be gone in a few days.

Bait Recipe

Ingredients:

1 Part Powdered Sugar

½ Part Borax or Baking Soda

½ Part Water, or as needed, for your desired Viscosity (Adding a food color makes it easier to know when bait is gone).

Instructions:

A - Combine Dry ingredients and Water in small saucepan. Bring to a Boil for 3 Min. then let cool. It will thicken as it cools.

B - Put mixture in a small bottle and Label “Ant Bait”.

C - You are all ready to Kill Ants. Put just a little Bait in the Bowl in the Trap, and leave where you have seen ants. They will gorge on it, take it back to the nest and it will kill the whole colony.

D - I added Red food color to mine so i could see when it needed refill.

E. For Fire Ants, put Crumbled Soda Cracker in Trap and pour mixture over the top. The Larger Ants will carry the crumbes back to the nest, killing all in the nest quicker.

The Photo with Ants on it, was about 30 minutes after Bait was set out.

Ant Trap / Bait Dispenser - Pet Safe with Recipe

0.2mm layer, 3 walls, 15% infill

0.2mm layer, 3 walls, 15% infill

0.2mm layer, 2 walls, 15% infill