There were always these little Benchy's all over the desk and falling over. I use these little ships to find color combinations or so that others can choose a color. Now all the little Benchy's have found a place and are beautifully displayed. Perfect for displaying with a stand or hanging on the wall.

I have constructed the following frame sizes:

1x1, 2x1, 2x2, 3x1, 3x2, 3x3, 4x1, 4x2, 4x3, 4x4, 5x1, 5x2, 5x3, 6x1, 6x2, 6x3, 6x4

I have also made a mounting frame that makes it easier for you to stick each benchy in the same position on the plate (plate.stl).

What do you need?
- Neodyn magnets in round with a diameter of 10mm and a height of 2mm (magnets round 10x2mm)
- viscous superglue
- a bunch of Benchy's

- Material to print in your desired color

How do you proceed?
1. Print all parts in the desired size.
2. Place the magnets in the plates and the frames and glue them together. Make sure that the attraction of the magnets fits together in the frame to the plate, otherwise your Benchy's will not be held.
3. Place the plates with magnets in the mounting device and glue the Benchy on top.
4. glue on the holders for hanging, into which you can later slide the stands if you want to stand up your Benchy picture frames and not hang them.
4.1. if you want to use a stand, I have constructed three different ones. one is small, the other is large and the third is large and narrow for picture frames that are larger, you can attach the latter holder to the left and right on the back of your picture frame.

5. Place your Benchy ships in the frames, the magnets will hold your Benchy's in place and you can show off your collection!

I recommend the following print settings:
- PLA, PETG or ABS
- 10 to 15 % infill
- 2 walls
- Support is not necessary!

BENCHY ship organizer / picture frame to stand or hang up!

0.2mm layer, 2 walls, 15% infill