This is a modified version of a publicly available 3D printable cell phone drawer / holder model, scaled uniformly by 10% in all dimensions to accommodate larger modern smartphones.

Important Notice: This file is not an original creation by us. It is derived from the original design created and shared by its respective author on [the original hosting site, e.g., Thingiverse/Printables/Cults3D/etc. – insert specific link if known]. We claim no ownership or copyright over the base model. All credit for the core design goes to the original creator(s). This modified version is shared solely for personal, non-commercial 3D printing use, in accordance with the original model's license (please check and respect the original file's license terms, such as Creative Commons or similar).

Modifications Made:

Uniform 10% scale increase applied to the entire model (using scaling factor of 1.1x) to provide additional clearance for bigger phones.
Successfully tested for fit with a Samsung Galaxy S25 Edge (dimensions approx. 158.2 × 75.6 × 5.8 mm) including a typical protective phone case. The phone slides in smoothly with comfortable clearance—no tightness or scraping observed.
Ideal for users with larger flagship devices (e.g., Samsung S25 series, iPhone 17 Pro Max equivalents, or phones with thicker cases) where the original size felt too snug.
Retains all original features: smooth drawer mechanism, secure storage, desk/under-desk mounting compatibility (if applicable to the base design), and clean printable geometry.
Recommended Use: Print in PLA, PETG, or ABS at your preferred layer height (0.2 mm suggested for balance of detail and strength). Supports may or may not be needed depending on orientation—test fit after printing a prototype section if desired.

This scaled variant enhances compatibility for 2025–2026 smartphones while preserving the elegant, functional spirit of the original design. Enjoy your upgraded phone drawer!

(For the original unmodified version, please visit the creator's page on the source platform.)

suporte celular Saveiro gol etc [ cell phone drawer]

0.2mm layer, 4 walls, 30% infill

10% larger each side good for S25 with phone case

0.2mm layer, 2 walls, 15% infill