The design remix utilises the great work done by d_v_ermakov on their 3 x CFS stand to take some of the parts and create a version to reduce the space needed for the CFS.

The new parts are front foot x 2 not handed

Rear feet x 2 using mirror feature to create right version of the left file here.

Parts reused from original model are Top rails left and right and 4 x foot for CFS.

I have included a 3MF project for a K1 max as that is what I used to print the parts. If using the Hi you will need to split the parts onto more plates and print in separate batches.

Using these parts you can create a stand as high as you want. Please note that the CFS cable is very tight due to the location of the socket on the side of the Hi. I bought a 2m replacement to enable me to increase the height if needed.

Note that the extruder needs room to home at the start of the print so if using lower profile as per the image make sure is back far enough so the extruder does not catch the CFS.

I have not had time to pull mine apart to measure the 2020 profile lengths and you might want to adjust these for your own preference. However the height of mine when assembled is 535mm from the bench to the top of the support rail. The size from the back of the rear foot to the front of the front foot is 520mm.

I hope this helps those of you with Hi printers and want a rack that does not attach to the printer or interfere with its operation.

I also found that the poop bin that fit well with this was already created and this is the link. https://www.crealitycloud.com/model-detail/67dd7b4164e6c7525b3d25cc?source=26

CFS Riser for Creality HI

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill