Needed a stand to raise my Creality Space Pi dryers (singles) about 30mm to allow adequate cooling as well as reduce the bend on the bowden tube since I print directly from them and feed to the top of my Ender 3 V3/V3 plus.

Saw a few online, but didn't want one that sat outside the edges of the dryer or one that was too overly complex, so decided to design one myself from scratch. I used PETG for heat resistance. This is a simple raised (30 mm) design with 4 feet. The stand is designed to be double stick taped to the underside of the dryer (see pics). I also designed reliefs / insets into the feet to allow placement of a rubber / foam rubber insert to prevent the stand from sliding / walking with vibration. The relief is 2 mm deep so I used a 3mm (1/8") rubber adhesive pad (sticky tape on one side) and cut it to fit inside the cutouts.

NOTE - the stand is not symmetrical front to back. The back foot should not over hand the dryer. If it does, flip it around. See pics - red "X" is incorrect. Green Checkmark is correct.

For the double stick tape I just used 3M. Make sure to clean the surfaces well with isopropyl alcohol and you should be fine.

There are also 2 versions of the stand. One with squared edges/corners and one with chamfered edges/corners for those that want a more rounded look. For those that would like the stand taller or shorter, you can just adjust the Z-height in your slicer but remember that you will be altering the depth of the foam rubber reliefs and may have to adjust accordingly.

UPDATE: Added a "V2" slightly upgraded version. This one has slightly wider (left to right) feed on the front and back of the Dryer for a bit more stability (they are narrower front to back but wider left to right by about 3/4"). Also made the frame just slightly more rigid (taller cross pieces).

Hope someone finds this useful. Thanks!

Creality Space Pi Dryer Stand - 30 mm elevation

0.2mm layer, 3 walls, 15% infill

0.2mm layer, 2 walls, 15% infill