This is a fully encode-able functioning cryptex with a fairly large storage compartment!

You will need to print:

1x cryptex ribbed body

1xcryptex slotted body

1x cryptex lock ring

6x cryptex key rings

6x cryptex adjustment rings

To input your own code simply align the slot on the inside edge of the adjustment ring with the desired letter on the key ring and click the two pieces together. This will be the key ring assembly. (You will have a total of 6 key ring assemblies)

To assemble the cryptex:

1: Slide the 6 key ring assemblies onto the slotted body in the desired order.

2:After all key ring assemblies are in place thread the lock ring onto the slotted body aligning the raised notch on the lock ring with the indentation on the slotted bodies base.

(The lock ring may not be tight and that is ok, it will not interfere with the operation of the cryptex.)

(The lock ring can be adjusted after complete assembly to adjust tension on the combination letters.)

3:Align the desired combination letters with the indentation on the slotted bodies base.

4:Slide the ribbed body into the slotted body and the aligned combination letters

5: Scramble combination letters in engage lock.

If you run into any problems that need attention with this model please feel free to leave a comment and I will address it as soon as possible!

Thank you and have fun!

Cryptex Storage Container

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill

Remix Models