Created by JHalye in August 18, 2023 called Dewalt 600 Router Edge Plate. for DCW600 and he states should fit DWP611.

- Very excited by this find! I think a tad bigger with those 608 bearings it will runs smoothly, so PERFECT FOR:

- chamfers on the edge

- edging round over

- Center Finding

- Tenons and Biscuits joining (is very doable by putting a clamp on each side to act as stoppers to avoid the bit for going to far off left and right)

- Dimensions for the plate: 100 x 240mm X 6 mm thick

-----------

*** MY ROUTER EDGER is the "Clear/White" Base with Yellow Spacer... I added a variation to it:

-- which is the use a real metal washer on both side of two stacked 608 bearings to make it even smoother to roll and more steady surface

-- So I printed 4x 8mm Spacer

-- Only 2x 12mm Spacer

-- since I did not have any lock nut but I had some split washer and threadlocker so I used that instead with a regular nut

---------

---Settings with PETG "translucent/clear":

- 0.2/0.4mm

- 5 walls/ 2mm --> I went very hard to get a very sturdy plate and to hold my bolts/bearing properly and been thrown around in my truck and around the shop!!

- 15% cubic infill since there's a lot of walls!

- no support but make sure to check the plate, there are 4 holes for the washer nuts that are recessed so need to be oriented properly

- I recommend a brim to help the plate to avoid distortion and for the Spacers to have something to stick to the plate

- I used blue painter's tape and glue as well.

-- for the Black Original Version: two of 8mm AND four of the 12mm (same settings as the base plate).

----------

===> My Version to assemble it (Clear/White Base w/ Yellow Spacers):

---> Parts / hardware needed and assemble in this order: (TWO SET OF THESE ARE NEEDED)

-- 1 Hex Bolt Nut 1.5" long: 1/4-20 ( total of 2)

-- 1 Washer for 1/4" bolt ( total of 4 including the other set below)

-- 2 8mm Spacer stack on top of each other ( print 4 of those)

-- 2 608 ZZ Skateboard Bearings (8x22x7mm) over the bearing spacers ( total of 4)

-- 1 Washer for 1/4" bolt ( already counted above)

-- 1 12mm Spacer ( print 2)

-- 1 Split Lock Washer (optional if you get a Nylon Lock Nut) ( total of 2 OR a total of 2 Nylon Lock Nut)

-- 1 1/4" - 20 Nut Bolt WITH THREADLOCKER (I used the Locktite ThreadLocker RED 271 - permanent) (total of 2 + threadlocker)

---------

===> The Original Black Version:

Added 2 - 1/4-20 1.5-in Hex bolts

Added 2 - 12 mm bolt spacers

Added 2 - 8mm bearing spacers

Added 2 - 608 ZZ Skateboard Bearings (8x22x7mm) over the bearing spacers

Added 2 - 12 mm bolt spacers

Finished with 2 1/4-20 Hex Lock nuts

Dewalt Router Edge Plate & Center Groove Biscuits and Tenons