Hi all, on this occasion I've remixed a Pokemon, Diglett to be more precise. I've chopped it a little and made a hole to place a nice succulent plant inside.

Thanks to https://www.printables.com/es/model/68566-diglett-pokemon for the awesome job modeling the original model.

I printed it on my Hellbot Magna SE Pro in around 4 hours at 125% scale. I used supports for the nose, but I believe it could be printed without them.

15% infill, 3 walls, 3 top layers, and 3 bottom layers.

Temperatures: 208°C and 60°C for the first layer, and 205°C and 55°C for the rest of the print.

Spanish version

/////////////////

Hi everyone, on this occasion I've remixed a Pokemon, Diglett to be more precise. I've cut it a little and made a hole to place a nice succulent plant inside.

Thanks to https://www.printables.com/es/model/68566-diglett-pokemon for the incredible job modeling the original model.

I printed it on my Hellbot Magna SE Pro in approximately 4 hours at 125% scale. I used supports for the nose, but I believe it could be printed without supports.

15% infill, 3 walls, 3 top layers, and 3 bottom layers.

Temperatures: 208°C and 60°C for the first layer, and 205°C and 55°C for the rest of the print.

Diglett Pokemon Planter

0.2mm layer, 2 walls, 15% infill

Original