Hey everyone!

I designed a simple mount for the Creality Nebula camera that attaches neatly along the Z-axis of the Ender 3 V3 Plus.

The camera’s point of view is aligned right at the height of the extruder, giving a perfect view of the printing process.

You don’t need any extra screws or modifications — just:

1 -Remove the screw that holds the small clip securing the cables next to the filament sensor.

2- Place the mount in that spot.

3- Reinsert the same screw.

4- Clip the cables into the mount’s built-in holder.

5- Install the Nebula Camera and route the cable under the mount

TIP: See the photos for a step-by-step guide — if you have any questions, just ask!

That’s it! The camera sits securely and the setup looks clean without adding any clutter or extra hardware.

I’m pretty happy with how it turned out — feedback or ideas for improvement are very welcome!

Hey, if you’re printing this camera mount, I also made a lateral spool holder that’s perfectly compatible with it — no collisions at all!

Ender 3 V3 Plus | Lateral Spool Holder (No Screws Needed)



________________________________________________________________________________________________________________________

Print settings (recommended):

Perimeters/Walls: 2

Layer height: 0.2 mm

Nozzle: 0.4 mm

Supports: Yes (AUTO)

Infill: 10%

Filament: PLA

Ender 3 V3 Plus | Z-Axis Nebula Camera Mount