Hi i made this as i could not find a good filament holder for the Ender3v3 Plus and it would on the Ender3v3 3d , alot of the models around dont use a bowden tube which causes undue wear and stress on the belts because your tool head is jeking the filament also they dont work well with the "xyz home" long story short i tried to make something that really just worked well and needed little or no non 3d printed parts.

I designed this filament holder to relocate the existing filament senor into the holder - it sits on a non static rail system that allow the filament sensor and guide to move as the filament spool gets lower / as the tool head moves left and right

the spool holder is easy to change spools , stable and i have test thoroughly before posting the model to ensure the holder has no negative effects on the printer

you will not need to extend the filament sensor wire

you dont need to use bearing you can just print the roller v2 its static but does the job fine

you dont need to have a bow-den tube feeding off the filament sensor input side - if you want one like I did in the photos just buy the parts on amazon just need 1 Bowden tube fitting and I suggest 60mm of tube this is total overkill but definitely need to have Bowden tube from the filament sensor to the tool head

Also need

6x40mm/50mm 3mm bolts or you can glue - don’t recommend that tho

make sure you have thread to the up not facing down to avoid anything getting caught on thread on the bottom clamp ie head of bolt closest to bed

threads facing out on filament sensor or in doesn’t matter that much

happy printing - please like and share

Ender 3v3 3d / plus Filament spool holder + filament sensor

0.2mm layer, 2 walls, 10% infill

0.2mm layer, 2 walls, 15% infill

Remix Models