Stylized chibi-style Frieren collectible figure in a crawling pose, designed as a cute display piece for 3D printing.
This model focuses on a soft anime-inspired look, clean silhouette, and a balanced pose that works well as a shelf or desk collectible.

The figure features:

stylized chibi proportions
clean anime facial design
detailed hair sculpt
elegant outfit with simple readable folds
compact pose suitable for display
This model is a good fit for:

anime figure collectors
resin 3D printing
painting practice
shelf decoration and personal collections\

Perfect as a small display statue for fans of fantasy anime aesthetics.

Recommended for resin printing.

Print recommendations:
Printer type: Resin / MSLA / SLA
Suggested height: 100–140 mm
Layer height: 0.03–0.05 mm
Bottom layers: 4–6
Bottom exposure: 20–35 s
Normal exposure: depends on your resin and printer settings
Orientation:
Tilt the model by about 25–40°
Avoid printing fully flat on the plate
Angle the figure to reduce suction and support marks
Supports:
Add supports manually in your slicer
Support the following areas carefully:hair tips
sleeves
hands and fingers
chin / face underside if needed
boots and lower edges of the outfit
Post-processing:
Wash the print properly
Remove supports carefully after washing
Cure fully after cleanup
Sand support marks lightly if needed
Important:
Supports are not included
Please check orientation and support placement before printing
Scaling the model may require adjusting support density

Frieren Chibi Figure – Curious Crawl Ver.