HX8 Magnet Pen Precise Control

Magnet Pen created by HX8 ED Design on Maker World

(https://**********.com/en/models/1752938-hx8-magnet-pen-precise-control#profileId-1867065)

Great for organizing and storing small magnets in the following sizes: 2mm, 3mm, 4.0mm, 4.5mm, 5mm, 6mm, 7mm, 8mm, and 10mm. Allows for easy placement/installation of magnets in DIY/cosplay projects. Comes with a custom Gridfinity holder. Additional body styles and pen holders are available on HX8 ED Design's Maker World page, using the link above. Detailed assembly instructions, with pictures, and demonstration GIF are also available using the link.

Print settings are attached for all pen sizes and the custom Gridfinity box/holder. All are based on the standard Creality presets: 0.28mm Standard @Creality K2 Plus 0.4 Nozzle.

Basic Assembly Instructions:

1. Spin the Gear Pusher into the body

2. Insert the black Magazine into the Gear Pusher.

3. Do not push the Magazine all the way to the end. First, push it about to half way (spin the Magazine until you can see the Gear Pusher through the side window.

4. Now, push the Magazine to the end. (ATTENTION: Twist the magazine to find the notch to insert to the end.)

5. Insert the Drive Cap.

6. Spin the Drive Cap all the way down to move the Gear Pusher to the end.

7. Glue one magnet to the Gear Pusher. (CAREFUL: do not put too much glue that could stick the Pusher with Magazine together.) I'd recommend using a super glue gel (e.g., Loctite Ultragel Control Super Glue) which is easier to control and dispense the appropriate amount, while permanently uniting the two pieces.

8. Install the Nozzle, and it's done.

9. Visit HX8 ED Design on Maker World (using the link above) and boost the original designer and this awesome project!

HX8 Magnet Pen - Easy Storage & Precise Control

0.2mm layer, 2 walls, 15% infill

0.25mm layer, 2 walls, 15% infill, abs

0.2mm layer, 2 walls, 15% infill