build is for the K2/K2 combo, will not work with any other model!

future ideas:
there will be a poop chute added to the mix soon enough and possible multiple different Iterations to the pipes but not the face plates with magnets.

Magnets:
the magnets size i used is 30x10x3, i did not use any of the adhesive they provided with the magnets. i super glued them in place.
i will provide a amazon link!
https://www.amazon.com/dp/B0C9L1ZYSX?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1

Foam "insert":
there will be a small 1mm indent on the bottom side of the faceplates. i did that for a small foam insert, its not to prevent air from escaping, its purpose is to stop it from sliding around and scratching the paint.
i will provide a amazon link!
https://www.amazon.com/dp/B07L6LGMWC?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1

Simple print:
I made straight adaptors for the faceplate to connect a dryer vent hose directly without having to print the complex pipes. i also made the Y connector to combine those two hoses into one.

I built this using TinkerCAD, this is my first ever build using that program!!

K2 Exhaust to 4in dryer hose