Three sizes of font sets for letterboards - half-inch, 3/4-inch, 1-inch peg spacing. This is a terrific font set, but for some existing letterboards, such as what is in my office, the peg spacing is set to english measurements: half-inch, 3/4-inch, 1-inch.

Our original font sets were disintegrating due to age, plus I wanted the possibility of color, other sizes, and more. I took this font set and scaled it for each of those sizes. When scaled up to 1 inch, the pegs were too thick to work with our letterboard, so I cut them in half. I kept the upper half of the peg, and that let to one small issue: if you put an "O" or a "0" upside-down, it will be slightly out of line with the rest of the letters, so keep an eye out.

I used Cura for a quick-and-dirty initial scaling, then Fusion 360 to change the pegs on the 1" version.

The half-inch files all start with "H - "
The 3/4-inch files all start with "Q - "
The 1-inch files all end with "half-peg."

I wanted to break these out to folders, but I didn't see a way in Creality Cloud to allow that, and I wasn't sure it takes ZIP files. I'll loop back when I have time to see if it's possible. NOTE: The tiny bit of stringing in the cover photo was fixed about 1 minute after my photo.

Letterboard Font Set - set to English sizes