Mounting bracket Ø17.5mm with coupling plate
This bracket can be attached to the upper part of an IV pole.
The coupling plate allows components to be quickly mounted or removed.
To do this, glue the coupling piece with the opening facing down to the back of a design you want to mount to the pole.
If there is still some space between the two parts of the mounting bracket, this space can be filled with 0.5 - 1.0 or 1.5 mm shims to prevent the bracket from breaking when it has to be tightened very tightly.

To attach the bracket, you need 4 M4 nuts and 4 M4 cylinder head Allen bolts (6-10mm thread).
The M4 nut goes on the back of the bracket section with the coupling plate. The easiest way to do this is to lay the plate flat on a surface, position the nut on the plate, and push a bolt through the hole above the nut, screw the bolt into the nut, and by tightening it, the nut is pulled securely into the designated hole. Remove the bolt again, and now you can secure both sections around a 17.5 mm pole.

Mounting bracket Ø17.5mm with coupling plate
This bracket can be attached to the upper part of an IV pole.
The coupling plate allows for quick installation and removal of components.
To do this, attach the coupling piece, with the opening facing down, to the back of the design you want to mount to the pole.
If there is still some space between the two parts of the mounting bracket, this space can be filled with the 0.5 - 1.0 or 1.5 mm shims to prevent the bracket from breaking when it has to be tightened very tightly.

To attach the bracket, you'll need 4 M4 nuts and 4 M4 cylinder head Allen bolts (6-10mm thread).
The M4 nut goes on the back of the bracket section with the coupling plate. The easiest way to do this is to lay the plate flat on a surface, position the nut on the plate, and push a bolt through the hole above the nut. Screw the bolt into the nut, and tighten it until the nut is securely fastened in the designated hole. Remove the bolt, and now you can secure both sections around a 17.5 mm post.

Mounting bracket Ø17.5mm

0.2mm layer, 4 walls, 20% infill

0.2mm layer, 2 walls, 15% infill