Overview

This project is a 3D printable mounting system that lets you hang a standard US pegboard over a door. It requires no screws, no drilling, and no damage to the door.

I designed this to organize my 3D printing tools and store filament spools inside my printing closet where they would be easily accessible.

Included Files

door_hook.stl - Top hook that hangs the pegboard over the door

door_hook_foot.stl - Spacer feet to keep the board off the door

door_hook_pin.stl - Locking pin that secures parts to the pegboard

How it Works

• The hooks clip onto the top of the pegboard and hang over the door.

• The feet attach to the middle and bottom of the pegboard to keep it spaced off the door.

• The pin friction-fits through the pegboard hole and locks both hooks and feet in place.

• No hardware required.

You can use as many hooks or feet as needed depending on pegboard size and load.

Print Settings

• Material: PLA

• Layer height: 0.2 mm

• Infill: 40–60% for hooks (higher if loading with filament spools), feet do not need much infill

• Walls: 3+ perimeters recommended

• Print hooks on their side for maximum strength across the layer lines

• Supports required for the hooks

Notes

• Designed for 1.375 inch thick doors. Measure your door before printing.

• Heavier loads may require additional hooks.

Over the Door Pegboard Hanger

0.2mm layer, 2 walls, 15% infill