Removable bin, trash can, or storage for whatever you like, that clips onto the edge of your desk.

Simply slides up off the bracket when it's time to be emptied.

Following common feedback from people, this is the third version of this project with an offset mounting bracket, to allow 100mm of the bin's edge to meet the desktop. This should make it easier to sweep the rubbish/trash straight into the bin with no obstructions and the desk bracket will help to guide the stuff in.

This V3 bin uses the same bracket screw and screw pad as the previous versions, so if you've already printed those 2 parts you don't need to reprint them.

If you're interested, the V2 model can be found here:

https://www.crealitycloud.com/model-detail/68118226bf737a7e52b46834?source=22

This model has been designed to be reasonably easy to print for newcomers and experienced printers alike. There is no need for supports or special print settings to make it work.

I have oriented the parts in the correct direction for printing, as seen in the model files thumbnail images.

The desk bracket is suitable for desktop thicknesses of 17-42mm.

*********EDIT 11/08/2025**********

As has been requested, I have added a file for a bracket that has 16mm extra depth, for desks with "non-square" edge (Bracket V3.1 extra depth.stl).

*********EDIT 08/08/2025**********

As has been requested, I have created a lid for this bin (fits both versions V3 and V3.1)

https://www.crealitycloud.com/model-detail/68958f343f4336b0b1838d8b?source=22

*********EDIT 21/07/2025**********

Added V3.1 files:

-Bin V3.1.stl has the steve__3d “watermark” in less conspicuous position

-Bracket V3.1.stl has the steve__3d “watermark” in less conspicuous position

-Bracket V3.1 extra height.stl is suitable for desktop thicknesses of 37-62mm

-Bracket V3.1 screws.stl has holes (with countersink) for screwing onto a surface

**************

Print settings I used:

0.2mm layer height

15% gyroid infill

3 walls (minimum I would suggest for the screw to increase strength)

Note: if you normally have bed adhesion issues, the screw part may be better to be printed with a brim

***************

Check out my other designs at:

https://www.crealitycloud.com/user/9054960261

If you think the design is ok, hit the like button. Or if you've got some improvement ideas, or anything else, leave it in the comments.

If you print it, leave a pic in the Makes, I'd like to see it.

Removable Desk Bin Trash Can V3

0.2mm layer, 3 walls, 15% infill

0.16mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill