Overview

This mounting clip was designed for RGB LED Neon Flex strips (including addressable IC variants such as WS2811/WS2812 types).

The original clips were either insufficient in quantity or did not provide the required holding strength for tighter curves and clean wall mounting.
Therefore, this clip was fully redesigned to provide a secure snap-fit while keeping installation simple using a single screw.

It works especially well for flexible silicone Neon LED strips that can be bent around corners.

Design Concept

The clip was designed with the following goals:

Secure snap-fit retention
Strong wall fixation with a centered screw hole
Minimal visible footprint
Clean appearance when mounted
Compatible with common Neon Flex widths
Easy printing without supports

The geometry allows the Neon Flex strip to snap in firmly while still being removable if needed.

Printing

The file is provided as a 3MF project file.

Inside the 3MF you can directly choose between:

PLA version
PETG version

This allows you to select the material that best fits your application without modifying the model.

Material Notes
PLA

Stiffer
Stronger snap-fit
Ideal for indoor decorative use

PETG

More flexible
Higher temperature resistance
Better for long LED runtime or warmer environments

Recommended Settings

Layer height: 0.2 mm
3–4 perimeters
30–50% infill
No supports required
Print flat on the base
For maximum durability, increase wall count rather than infill.

Installation

Position clip on wall.
Fix using a suitable screw.
Snap Neon Flex strip into the clip.

Make sure the screw head does not protrude too much to avoid interference.

RGB-LED Neon Flex Wall Mount Clip

0.2mm layer, 4 walls, 15% infill