Product Description

<Product Name>

Silica Gel Cartridge for Filament Spool

This cartridge is designed to hold bead-type silica gel and attach directly to your filament spool, helping to keep your filament dry and protected from moisture. The mesh structure and included optional spacers ensure compatibility with various spool thicknesses.

Compatible with bead-type silica gel: Simply fill the cartridge and mount it onto your filament spool.

1.5 mm mesh openings: Please use silica-gel beads sized 2.0 mm or larger to prevent beads from falling out.

Adjustable spacer system: Each spacer is 3 mm thick, and up to 6 mm of adjustment can be added using the included data if the cartridge does not fit tightly on thinner spools.

Optional spacer printing: Spacers are intended for spools that are too thin to secure the cartridge when fully tightened. If not needed, we recommend not printing them to save filament.

Easy-to-align cap: The cap is clearly labeled “TOP” to ensure proper orientation when attaching or removing it.

1.Ensure that the area of the filament spool where the cartridge will make contact is at least 53 mm thick.

(If it is less than 53 mm, print and use the included spacer.)

2. Fill the cartridge with bead-type silica gel.

3. If a spacer is required, insert it into the cartridge with the rimmed side facing downward.

4. Lay the filament spool on its side and align its center hole with the cartridge, then fit the spool onto the cartridge.

5. Attach the cap with the “TOP” label facing upward, and tighten it to secure the spool.

1. Remove the filament spool from your 3D printer.

2. With the “TOP” label facing upward, twist the cap to remove it from the cartridge.

3. Lift the filament spool upward to detach it from the cartridge.

Silica Gel Cartridge for Filament Spool

0.08mm layer, 4 walls, 20% infill

0.2mm layer, 2 walls, 15% infill