Bring a piece of Tamriel into the real world! 🐉

Whether you're a die-hard fan of The Elder Scrolls V: Skyrim or looking for the perfect accessory for your next cosplay, this meticulously designed pendant features the iconic Imperial Dragon emblem (Akatosh).

The geometry has been strictly respected and designed to be printed with a stunning multi-material look, mimicking precious materials: a fine marble border, a dark obsidian core, and a shining silver dragon.

Recommended Filament Colors (To match the render):

To achieve the premium, realistic look shown in the pictures, we highly recommend the following filament choices:

Border (Outer Edge): PLA Marble (for a realistic stone finish)

Background (Core): Standard PLA Black (to mimic dark, opaque obsidian)

Dragon Emblem: PLA Silk Silver (for a shiny, metallic forged look)

🖨️ Recommended Print Settings :

This model is highly optimized for 3D printing and is very easy to print if you follow these guidelines:

Orientation: Print flat on its back. The model is designed to sit perfectly flush against the build plate.

Supports: Allow supports to be generated from the piece (not only on buildplate), and choose black PLA for support. Some details of the dragon needs to be supported to be well printed and if you don't choose black you could have silvery white bits incrusted on the black obsidian background

Layer Height: 0.16 mm is highly recommended to capture the sharp, fine details of the dragon's wings and tail.

Infill: 25% (Honeycomb). Since it's a thin pendant, you can also print it at 100% infill for a heavier, more premium "jewelry" feel.

Top Surface / Ironing: Enable Ironing (All top surfaces). This is the secret to getting that perfectly smooth, glassy "obsidian" look on the black background and a polished finish on the silver dragon.

Bed Adhesion: No skirt is fine. If you struggle with sharp corners warping on the diamond shape, then consider a small brim.

Hole Ring: The top hole is pre-designed to easily fit a standard necklace ring or leather cord. No drilling required.

Multi-Color Printing Tips:

*For AMS/MMU Users: The model can be easily painted in your slicer to assign the Marble, Black, and Silk Silver spools.

*For Single Extruder Users: You can easily achieve this look by adding Pause at Height (M600) commands in your slicer to swap filaments at the specific layer heights where the background ends and the dragon begins. But this will limit the print to two colours and the side of the pendant will not be uniform

Skyrim Imperial Dragon Pendant / Akatosh Amulet

0.2mm layer, 2 walls, 15% infill