Print the clamp and screw with heavy perimeters and infill for strength. No support required.If you're using it for hot drinks, don't print it from PLA.

Update 26/06/20: Added a wider (95mm dia) version of the cupholder for larger cups.

Update 12/6/21: Added a reversed bracket for people who want the clamping knob up top.

Update 22/01/23: Added a larger bracket for big desks (50mm).

----------------------------

Working from home often results in beverages and computer equipment sharing the same desk. This is a perpetually hazardous arrangement (and I speak from experience).

This design is for a cup/drink holder that places the beverage below desk level. This means that mishaps should result in nothing more than getting the floor messy, while keeping the desk, computer, and other important things safe.

It should fit desks from 40mm thick to 8mm thick.

If you do have a very slippery table and are worried about it slipping, I'd recommend some silicone furniture pads, like these: https://www.bunnings.com.au/taskmaster-12-7-x-1-5mm-door-buffer-100-pack_p0290558

The Laptop Saver - A sub-desk level drink holder

0.2mm layer, 2 walls, 8% infill

0.2mm layer, 2 walls, 8% infill

0.2mm layer, 2 walls, 15% infill