Toyota Starlet Centre armrest and storage provide an aesthetic and comfortable solution to add additional storage to the Toyota Starlet models that do not come with the armrest included.

The armrest box is split into 2 models, as I could not fit it on my K1C printer bed. I have included both the STL that splits the armrest box in half and the One Piece full box STL. I have also included the 3mf file with the settings I used, as well as all the added modifiers to prevent the fuzzy skin from disrupting the dimensional accuracy.

Parts to Print: (Split arm rest Box)

1x Front Full

1x Back

1x Arm Rest

2x Clip

Parts to Print: (One Piece Armrest Box)

1x One Piece Full Box

1x Arm Rest

The Model will require supports to be added.

Additional hardware required:

2X M3x 18mm (only for Split box STL model)

8X M3x 6mm

2X Hinges W20mm x L100mmx H1.5mm

https://leroymerlin.co.za/flap-hinge-narrow-100x20-galvanized-81487481

Assembly Instructions:

1) Remove all supports from the prints.

2) Place the front and back together.

(Not for One Piece Full Box)

3) Screw in the 2X 18mm M3 screws into the holes at the bottom of the Back Box through to the front box to hold the front and back together securely. (Not for One Piece Full Box)

4) Place the clip into the slots on the top of the front and back, and firmly press them into place. (Not for One Piece Full Box)

5) Push the hinges into the holes on the Back Box, and then, using the 4X 6mm M3 screws, Secure the hinges into the back.

6) Place the hinges into the slot on the armrest and then secure the hinges into the armrest with 4X 6mm M3 screws.

7) Once fully assembled, simply place it into the cupholder in your Toyota Starlet.

Toyota Starlet Centre armrest and storage

0.2mm layer, 2 walls, 15% infill