An improved version of my USB/USBc cable holders featuring:

✅ Enhanced strength

✅ 3 screw lengths

✅ 3/4x cable holder variants

✅ Fits square table edges

A small but capable cable holder useful for stowing USBc/lightning/microUSB cables.

For table tops less of 0-3cm.

Comes with a pre-generated brim for better bed adhesion.

Print instructions:

1) Load up the 3mf 'All 6 Cable Holders'

2) Delete the types you don't need

3) Print!

4) Cut or snap off easy to remove brim

Easy print settings:

-Wall loops 2-4

-Infill >30%

-Support None

-Brim None

*Times estimated for high speed printers such as: K1, K1max, X1C, p1s etc.

For additional settings see below:

Dimensions (For USBc 2x only):

Length - 35mm

Width - 34mm

Height - 47mm+

Gap width - 30mm

Additional settings:

-Layer height 0.2mm

-Detect thin wall No

-Filament(s) used in demo N/A

Maker's comments:

Wires fit easily with a little wiggle room, although the rim does a good job at preventing the end from falling out. In testing 15% infill gave low stiffness, so it is recommended to either increase wall thickness of 3-4 walls OR use >30% infill.

Any questions/suggestions? Please comment down below and I'll be happy to help in any way I can.

Wire Holder - USB & USBc - Screw Clamp

All 6 Cable Holders

0.2mm layer, 2 walls, 15% infill